ECD SYSTEM > Air Conditioning Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (AIR CONDITIONING SIGNAL) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the A/C switch ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / A/C SIG.
| A/C Compressor | Display |
| OFF | A/C SIG OFF |
| ON | A/C SIG ON |
|
| ||||
| NG | |
| 2.CHECK ECM (AC1 VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E22-2 (AC1) - Body ground | A/C compressor ON | Below 1.5 V |
| E22-2 (AC1) - Body ground | A/C compressor OFF | 7.5 to 14 V |
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the A14 A/C amplifier connector.
Disconnect the E22 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A14-14 (AC1)* - E22-2 (AC1) | Below 1 Ω |
| E22-2 (AC1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 1.CHECK ECM (AC1 VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E22-2 (AC1) - Body ground | A/C compressor ON | Below 1.5 V |
| E22-2 (AC1) - Body ground | A/C compressor OFF | 7.5 to 14 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the A14 A/C amplifier connector.
Disconnect the E22 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A14-4 (AC1)* - E22-2 (AC1) | Below 1 Ω |
| E22-2 (AC1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||