Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > Air Conditioning Signal Circuit

for Preparation Click here


DESCRIPTION

When the A/C compressor is on, the A/C amplifier sends the A/C signal to the ECM, then the ECM increases the fuel injection volume to improve driveability during engine idling.

WIRING DIAGRAM


A119279E01


INSPECTION PROCEDURE


When using intelligent tester:

1.READ VALUE USING INTELLIGENT TESTER (AIR CONDITIONING SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the A/C switch ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / A/C SIG.

    Result:
    A/C Compressor
    Display
    OFF
    A/C SIG OFF
    ON
    A/C SIG ON



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK ECM (AC1 VOLTAGE)


    A276509E02
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-2 (AC1) - Body ground
    A/C compressor ON
    Below 1.5 V
    E25-2 (AC1) - Body ground
    A/C compressor OFF
    7.5 to 14 V



OK
REPLACE ECM
NG


3.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E19
  1. Disconnect the A14 A/C amplifier connector.

  1. Disconnect the E25 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A14-14 (AC1)* - E25-2 (AC1)
    Below 1 Ω
    E25-2 (AC1) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER 


When not using intelligent tester:

1.CHECK ECM (AC1 VOLTAGE)


    A276509E02
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-2 (AC1) - Body ground
    A/C compressor ON
    Below 1.5 V
    E25-2 (AC1) - Body ground
    A/C compressor OFF
    7.5 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E19
  1. Disconnect the A14 A/C amplifier connector.

  1. Disconnect the E25 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A14-4 (AC1)* - E25-2 (AC1)
    Below 1 Ω
    E25-2 (AC1) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER