ECD SYSTEM > Air Conditioning Cut Control Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (CHECK OPERATION AIR CONDITIONING CUT CONTROL) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the air conditioning switch ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test / A/C Cut SIG.
Check operation of A/C magnetic clutch cut when air conditioning cut control is operated by the intelligent tester.
|
| ||||
| NG | |
| 2.INSPECT ECM (ACT VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E22-8 (ACT) - Body ground | Engine at idling | 9 to 14 V |
| E22-8 (ACT) - Body ground | Ignition switch ON, Engine stopped | 0 to 3 V |
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the A14 A/C amplifier connector.
Disconnect the E22 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A14-2 (ACT)* - E22-8 (ACT) | Below 1 Ω |
| E22-8 (ACT) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 1.CHECK ECM (ACT VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E22-8 (ACT) - Body ground | Engine at idling | 9 to 14 V |
| E22-8 (ACT) - Body ground | Ignition switch ON, Engine stopped | 0 to 3 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the A14 A/C amplifier connector.
Disconnect the E22 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A14-2 (ACT)* - E22-8 (ACT) | Below 1 Ω |
| E22-8 (ACT) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||