Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > Air Conditioning Cut Control Circuit

for Preparation Click here


DESCRIPTION

This circuit cuts air conditioning operation during vehicle acceleration in order to increase acceleration performance. During acceleration with the vehicle speed at 30 km/h (19 mph) or less and accelerator pedal opening angle at 45° or more, the A/C magnetic switch is turned off for several seconds.
The air conditioning is also controlled by the ECM outputting the engine coolant temperature to A/C amplifier.

WIRING DIAGRAM


A119279E02


INSPECTION PROCEDURE


When using intelligent tester:

1.READ VALUE USING INTELLIGENT TESTER (CHECK OPERATION AIR CONDITIONING CUT CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the air conditioning switch ON.

    HINT:
    A/C magnetic clutch is turned ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / A/C Cut SIG.

  1. Check operation of A/C magnetic clutch cut when air conditioning cut control is operated by the intelligent tester.

    OK:
    A/C magnetic clutch is turned OFF.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT ECM (ACT VOLTAGE)


    A276509E03
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-8 (ACT) - Body ground
    Engine at idling
    9 to 14 V
    E25-8 (ACT) - Body ground
    Ignition switch ON, Engine stopped
    0 to 3 V



OK
REPLACE ECM
NG


3.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E20
  1. Disconnect the A14 A/C amplifier connector.

  1. Disconnect the E25 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A14-2 (ACT)* - E25-8 (ACT)
    Below 1 Ω
    E25-8 (ACT) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER 


When not using intelligent tester:

1.CHECK ECM (ACT VOLTAGE)


    A276509E03
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-8 (ACT) - Body ground
    Engine at idling
    9 to 14 V
    E25-8 (ACT) - Body ground
    Ignition switch ON, Engine stopped
    0 to 3 V



OK
REPLACE ECM
NG


2.CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E20
  1. Disconnect the A14 A/C amplifier connector.

  1. Disconnect the E25 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A14-2 (ACT)* - E25-8 (ACT)
    Below 1 Ω
    E25-8 (ACT) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER