Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1203    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

This circuit is used to send control information from the skid control ECU (brake actuator assembly) to the ECM and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1203
The engine, drivetrain and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
ECM

INSPECTION PROCEDURE

1.CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
  1. Check that the proper ECM and brake actuator assembly are installed.
    Result 
    Result
    Proceed to
    Proper ECUs are installed
    A
    Proper ECUs are not installed
    B



B
REPLACE ECUS WITH PROPER ONES
A


2.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output.

    HINT:
    Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    for 1GR-FE
    B
    for 1KD-FTV
    C
    for 2KD-FTV
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)