DTC C1210 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336 Zero Point Calibration of Acceleration Sensor Undone |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1210 | Zero point calibration of the yaw rate sensor is incomplete. |
|
| C1336 | Zero point calibration of the acceleration sensor is incomplete. |
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the sensor check in the Test Mode procedure (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (DECELERATION SENSOR / YAW RATE SENSOR) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Deceleration Sensor | Acceleration sensor (GL1) / Min.: -18.525 m/s2, Max.: 18.387 m/s2
| - | Changes continuously during acceleration/deceleration. |
| Deceleration Sensor2 | Acceleration sensor (GL2) / Min.: -18.525 m/s2, Max.: 18.387 m/s2
| - | Changes continuously during acceleration/deceleration. |
| Yaw Rate Sensor | Yaw rate sensor / Min.: -128°/s, Max.: 127°/s | Vehicle stationary: 0°/s Right turn: -128 to 0°/s Left turn: 0 to 127°/s | - |
Check the yaw rate and acceleration sensor output value displayed on the intelligent tester.
|
| ||||
| OK | ||
| ||