Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1000/31    Center Airbag Sensor Assembly Malfunction

for Preparation Click here


SYSTEM DESCRIPTION

The center airbag sensor consists of an airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control circuit, etc.
If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.
DTC B1000/31 is stored when a malfunction is detected in the center airbag sensor.

DTC No.
DTC Detection Condition
Trouble Area
B1000/31
Center airbag sensor assembly malfunction
Center airbag sensor assembly

HINT:
When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.


INSPECTION PROCEDURE

1.CHECK CENTER AIRBAG SENSOR
  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1000/31 is output
    A
    DTC B1000/31 and other DTCs are output
    B

    NOTICE:
    If only DTC B1000/31 is output, do not clear the DTCs. Instead, immediately replace the center airbag sensor assembly.

    HINT:
    If any DTCs other than DTC B1000/31 are output, troubleshoot those DTCs first.



A
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
B

GO TO DIAGNOSTIC TROUBLE CODE CHART