AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Radio Broadcast cannot be Received (Bad Reception) |

| 1.CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY |
Check the radio automatic station search function by activating it.
|
| ||||
| OK | ||
| ||
| 2.CHECK OPTIONAL COMPONENTS |
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
|
| ||||
| OK | ||
| ||
| 3.CHECK ANTENNA FOR NOISE PRODUCTION |
Remove the quarter window assembly RH (window glass antenna wire) connector.
With the ignition switch ACC, turn on the radio and choose the AM mode.
Place a screwdriver, thin wire or other metal object on the navigation receiver assembly antenna connector and check that noise can be heard from the speakers.
|
| ||||
| OK | ||
| ||
| 4.CHECK RADIO RECEIVER ASSEMBLY (ANTENNA) |
![]() |
Remove the antenna connector from the radio receiver assembly.
Turn the ignition switch to ACC with the radio receiver assembly connector connected.
Turn on the radio and turn into AM mode.
Place a screwdriver, thin wire or other metal object on the radio receiver assembly antenna jack and check that noise can be heard from the speakers.
|
| ||||
| OK | |
| 5.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the RA radio receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (ANT+) - Body ground | Ignition switch ACC, radio switch on and FM or AM selected | 11 to 14 V |
|
| ||||
| OK | |
| 6.CHECK ANTENNA CORD SUB-ASSEMBLY |
![]() |
Disconnect the radio receiver assembly connector.
Remove the antenna connector from the antenna with holder assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| RA-3 (MAIN) - 2 | Always | Below 1 Ω |
| RA-5 (ANT+) - 3 | Always | Below 1 Ω |
| RA-3 (MAIN) - Body ground | Always | 10 kΩ or higher |
| RA-5 (ANT+) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio Receiver Assembly) |
| *b | Front view of wire harness connector (to Antenna with Holder Assembly) |
|
| ||||
| OK | |
| 7.CHECK ANTENNA WITH HOLDER ASSEMBLY |
Replace the antenna with holder assembly and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||
| 8.INSPECT QUARTER WINDOW ASSEMBLY RH |
![]() |
Inspect the quarter window assembly RH (window glass antenna wire).
| *1 | Antenna Wire |
| *2 | Tin Foil |
| *3 | Tester Probe |
![]() |
Check the voltage at the center of each wire as shown in the illustration.
|
| ||||
| OK | ||
| ||