RADIO RECEIVER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
for Manual Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 10 claws and 4 clips.
![]() |
Detach the 4 claws and disconnect the air conditioner control.
Disconnect the connectors and remove the center instrument cluster finish panel.
![]() |
for Automatic Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 3. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type) |
![]() |
Remove the 4 screws.
Pull out the radio receiver assembly to detach the 2 clips on the backside of the radio receiver assembly with bracket.
![]() |
Detach the wire harness clamp.
Disconnect all the connectors and remove the radio receiver assembly with bracket.
| 4. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) |
![]() |
Remove the 4 screws.
Pull out the radio and display receiver assembly to detach the 2 clips on the backside of the radio and display receiver assembly with bracket.
![]() |
Detach the wire harness clamp.
Disconnect all the connectors and remove the radio and display receiver assembly with bracket.
| 5. REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type) |
![]() |
Remove the 3 screws and No. 1 radio bracket from the radio receiver assembly.
| 6. REMOVE NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type) |
![]() |
Remove the 3 screws and No. 1 radio bracket from the radio and display receiver assembly.
| 7. REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type) |
![]() |
Remove the 3 screws and No. 2 radio bracket from the radio receiver assembly.
| 8. REMOVE NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type) |
![]() |
Remove the 3 screws and No. 2 radio bracket from the radio and display receiver assembly.