Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE RADIATOR GRILLE


    B277882
  1. Remove the 2 clips and 2 screws.



    B277883E01
  1. Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 6 claws and remove the radiator grille.



4. REMOVE BATTERY CLAMP SUB-ASSEMBLY
  1. Remove the bolt and battery bracket.



5. REMOVE BATTERY
  1. Disconnect the cable from positive (+) battery terminal.

  1. Remove the battery.



6. REMOVE FRONT AIRBAG SENSOR LH


    B277574
  1. Remove the nut and front airbag sensor LH.

  1. Disconnect the connector.