Home › INTRODUCTION › INTRODUCTION › REPAIR INSTRUCTION

REPAIR INSTRUCTION > INITIALIZATION



PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL

Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal 
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See page
for Driver Side, w/ Jam protection
Power window regulator motor initialization
  1. Jam protection function
  2. Power window control system
Click here

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See page
ECM (for 1KD-FTV)
  1. Learning values save
  2. Learning values write
Engine starting
Click here
Engine assembly (for 1KD-FTV)
  1. Injector compensation code
  2. Pilot quantity learning
Engine starting
Fuel injector (for 1KD-FTV)
  1. Injector compensation code registration
  2. Pilot quantity learning
Engine starting
Fuel supply pump (for 1KD-FTV)
Supply pump initialization
Engine startability
Click here
ECM (for 2KD-FTV)
  1. Learning values save
  2. Learning values write
Engine starting
Click here
Engine assembly (for 2KD-FTV)
  1. Injector compensation code
  2. Pilot quantity learning
Engine starting
Fuel injector (for 2KD-FTV)
  1. Injector compensation code registration
  2. Pilot quantity learning
Engine starting
Fuel supply pump (for 2KD-FTV)
Supply pump initialization
Engine startability
Click here
A750E
  1. Automatic transmission assembly
  2. ECM
  3. Engine assembly
Reset memory
Large shift shock
Click here
A750F
  1. Automatic transmission assembly
  2. ECM
  3. Engine assembly
Reset memory
Large shift shock
Click here
Skid control ECU (Brake actuator assembly)
Yaw rate and acceleration sensor zero point calibration
VSC
Click here
  1. Yaw rate sensor assembly
  2. Front wheel alignment adjustment
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
VSC
for Built-in Type Door Control Receiver
  1. Theft warning ECU assembly
  2. Key
Recognition code registration
Wireless door lock control system
Click here
for Non-built-in Type Door Control Receiver
  1. Door control receiver assembly
  2. Key
Recognition code registration
Wireless door lock control system
Click here
  1. Transponder key ECU assembly
  2. ECM
  3. Key
Code registration
Engine starting
Refer to the Service Bulletin for the registration procedure.
Timing belt (for 1KD-FTV, 2KD-FTV)
Mode reset operation
  1. Does not illuminate when replacement is necessary
  2. Illuminates when replacement is not necessary
Click here
for Driver Side, w/ Jam protection
  1. Front power window regulator motor
  2. Front door window regulator sub-assembly
Motor initialization
  1. Jam protection function
  2. Power window control system (w/ Jam protection function)
Click here
  1. Height control sensor
  2. Headlight leveling ECU
Headlight leveling ECU initialization
Headlight leveling function
Click here