Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL SENSOR CLAMP


    C189954
  1. Install the skid control sensor clamp with the bolt.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Make sure the clamp rotation stopper touches the installation position.



2. INSTALL REAR SPEED SENSOR RH


  1. Install the speed sensor with the bolt.


    C189955E01

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

  1. Attach the 6 clamps.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.

  1. Connect the connector.

    NOTICE:
    1. Pass the sensor connector between the brake tube and axle housing before connecting it to the wire harness connector on the vehicle.
    2. Securely connect the connector.
    3. When connecting the connector, do not twist the wire harness.

  1. Attach the connector to the skid control sensor clamp.



3. INSTALL REAR SPEED SENSOR LH


  1. Install the speed sensor with the bolt.


    C189956E01

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

  1. Attach the 3 clamps.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.

  1. Connect the connector.

    NOTICE:
    1. Securely connect the connector.
    2. When connecting the connector, do not twist the wire harness.

  1. Attach the connector.



4. INSTALL REAR WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. CHECK SPEED SENSOR SIGNAL
  1. w/ ABS:
    Check the speed sensor signal (Click here).

  1. w/ VSC:
    Check the speed sensor signal (Click here).