Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM


C240177E06


INSPECTION PROCEDURE

1.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C217121
  1. Remove the parking brake switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector - Switch body
    On (Shaft is not pressed)
    Below 1 Ω
    Off (Shaft is pressed)
    10 kΩ or higher

    Text in Illustration 
    V100135
    On
    V100136
    Off



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH)
  1. Disconnect the R20 radio and display receiver assembly connector.

  1. Disconnect the P3 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R20-6 (PKB) - P3-1
    Always
    Below 1 Ω
    R20-6 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)