Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


WIRING DIAGRAM


E234747E04


E234747E05


INSPECTION PROCEDURE

1.CHECK SEAT TYPE
  1. Check seat type.
    Result 
    Result
    Proceed to
    w/ Power Seat Control System
    A
    w/o Power Seat Control System
    B



B
Go to step 4
A


2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH)


    E174267E03
  1. Disconnect the F24 front seat inner belt assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Seat belt is unfastened
    Below 1 Ω
    1 - 4
    Seat belt is fastened
    1 MΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT - COMBINATION METER AND BODY GROUND)
  1. Disconnect the F24 front seat inner belt assembly connector.

  1. Disconnect the C27 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F24-1 - C27-11 (BKL)
    Always
    Below 1 Ω
    F24-4 - Body ground
    Always
    Below 1 Ω
    F24-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)  

4.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH)
E174266E04
  1. Disconnect the F11 front seat inner belt assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened
    Below 1 Ω
    1 - 2
    Seat belt is fastened
    1 MΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (Click here)
OK


5.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT - COMBINATION METER AND BODY GROUND)
  1. Disconnect the F11 front seat inner belt assembly connector.

  1. Disconnect the C27 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F11-1 - C27-11 (BKL)
    Always
    Below 1 Ω
    F11-2 - Body ground
    Always
    Below 1 Ω
    F11-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)