METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate |


| 1.CHECK SEAT TYPE |
Check seat type.
| Result | Proceed to |
| w/ Power Seat Control System | A |
| w/o Power Seat Control System | B |
|
| ||||
| A | |
| 2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH) |
![]() |
Disconnect the F24 front seat inner belt assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 4 | Seat belt is unfastened | Below 1 Ω |
| 1 - 4 | Seat belt is fastened | 1 MΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT - COMBINATION METER AND BODY GROUND) |
Disconnect the F24 front seat inner belt assembly connector.
Disconnect the C27 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F24-1 - C27-11 (BKL) | Always | Below 1 Ω |
| F24-4 - Body ground | Always | Below 1 Ω |
| F24-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH) |
![]() |
Disconnect the F11 front seat inner belt assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Seat belt is unfastened | Below 1 Ω |
| 1 - 2 | Seat belt is fastened | 1 MΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT - COMBINATION METER AND BODY GROUND) |
Disconnect the F11 front seat inner belt assembly connector.
Disconnect the C27 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F11-1 - C27-11 (BKL) | Always | Below 1 Ω |
| F11-2 - Body ground | Always | Below 1 Ω |
| F11-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||