DTC 42 Vehicle Speed Sensor Signal Circuit Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| 42 | All conditions below are detected continuously for 8 sec. or more:
|
|

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check whether the operation of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the tester.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
![]() |
Disconnect the combination meter connector.
Disconnect the ECM connector.
Measure the resistance according the value(s) in the table below.
| Tester Connection | Specified Condition |
| C27-6 - E20-9 (SP1) | Below 1 Ω |
| C27-6 or E20-9 (SP1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK COMBINATION METER ASSEMBLY (+S VOLTAGE) |
![]() |
Disconnect the combination meter connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-6 - Body ground | Ignition switch on | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 5.CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL OUTPUT WAVEFORM) |
![]() |
Remove the combination meter assembly.
Connect the combination meter connector.
Move the shift lever to the neutral position.
Jack up one of the rear wheels.
Turn the ignition switch to ON.
Check the voltage between the terminal of the combination meter and the body ground while the rear wheel is turned slowly.
| Tester Connection | Condition | Specified Condition |
| C27-6 - Body ground | Ignition switch on Turn wheel slowly | Voltage generated intermittently |
|
| ||||
| OK | ||
| ||
| 6.CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL INPUT WAVEFORM) |
![]() |
Remove the combination meter assembly.
Connect the combination meter connector.
Move the shift lever to the neutral position.
Jack up one of the rear wheels.
Turn the ignition switch to ON.
Check the voltage between the terminal of the combination meter and the body ground while the rear wheel is turned slowly.
| Tester Connection | Condition | Specified Condition |
| C27-5 - Body ground | Ignition switch on Turn wheel slowly | Voltage generated intermittently |
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (COMBINATION METER - SPEEDOMETER SENSOR) |
![]() |
Disconnect the combination meter connector.
Disconnect the speedometer sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-5 - S3-3 (SI) | Always | Below 1 Ω |
| C27-5 or S3-3 (SI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||