Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Steering Pad Switch Circuit

for Preparation Click here


DESCRIPTION

  1. *1: w/ Accessory Meter
  2. *2: w/o Accessory Meter
This circuit sends an operation signal from the steering pad switch assembly*1 or steering pad switch LH*2 to the radio receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2.
If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.
Therefore, the radio receiver assembly cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2, and the radio receiver assembly itself cannot function.

WIRING DIAGRAM


E278184E12


INSPECTION PROCEDURE

CAUTION:
The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (Click here).

1.INSPECT STEERING PAD SWITCH
  1. *1: w/ Accessory Meter
  2. *2: w/o Accessory Meter
  1. Remove the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).

  1. Inspect the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).
    Result 
    Result
    Proceed to
    OK
    A
    NG (w/ Accessory Meter)
    B
    NG (w/o Accessory Meter)
    C



B
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)

C
REPLACE STEERING PAD SWITCH LH (Click here)
A


2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. Remove the spiral cable sub-assembly (Click here).

  1. Inspect the spiral cable sub-assembly (Click here).



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
  1. Disconnect the R27 radio receiver assembly connector.

  1. Disconnect the S30 spiral cable sub-assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R27-21 (SW1) - S30-6 (AU1)
    Always
    Below 1 Ω
    R27-22 (SW2) - S30-5 (AU2)
    R27-23 (SWG) - S30-4 (EAU)
    R27-21 (SW1) - Body ground
    Always
    10 kΩ or higher
    R27-22 (SW2) - Body ground
    R27-23 (SWG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)