AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Steering Pad Switch Circuit |

| 1.INSPECT STEERING PAD SWITCH |
Remove the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).
Inspect the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).
| Result | Proceed to |
| OK | A |
| NG (w/ Accessory Meter) | B |
| NG (w/o Accessory Meter) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the R19 radio and display receiver assembly connector.
Disconnect the S30 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R19-21 (SW1) - S30-6 (AU1) | Always | Below 1 Ω |
| R19-22 (SW2) - S30-5 (AU2) | Always | Below 1 Ω |
| R19-23 (SWG) - S30-4 (EAU) | Always | Below 1 Ω |
| R19-21 (SW1) - Body ground | Always | 10 kΩ or higher |
| R19-22 (SW2) - Body ground | Always | 10 kΩ or higher |
| R19-23 (SWG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||