Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for KD Series Engine)

CLUTCH UNIT (for KD Series Engine) > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
for R151 manual transmission: (Click here).
for R150F/R151F manual transmission: (Click here).


2. REMOVE CLUTCH RELEASE FORK BOOT


3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY
  1. Remove the clutch release bearing assembly together with the clutch release fork sub-assembly from the clutch housing.

  1. Remove the clutch release fork sub-assembly from the clutch release bearing assembly.

  1. Remove the release bearing hub clip from the clutch release bearing assembly.



4. REMOVE RELEASE FORK SUPPORT
  1. Remove the release fork support from the manual transmission unit.



5. REMOVE CLUTCH COVER ASSEMBLY


D029616E03
  1. Place matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



6. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.



7. INSPECT INPUT SHAFT FRONT BEARING


Q002481E04
  1. Turn the bearing by hand by applying rotational force.
    If the bearing sticks or has much resistance, replace the input shaft bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.



8. REMOVE INPUT SHAFT FRONT BEARING


    Q007150E01
  1. Remove any 2 diametrically opposite bolts.

  1. Using SST, remove the input shaft bearing.

    SST
    09303-35011