MANUAL TRANSMISSION ASSEMBLY > REMOVAL |
| 1. REMOVE CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE CONSOLE BOX ASSEMBLY |
| 3. REMOVE SHIFT LEVER BOOT ASSEMBLY |
![]() |
Remove the 4 screws, 2 clips and shift lever boot.
| 4. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY |
![]() |
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it counterclockwise to remove it.
Pull out the shift lever.
| 5. REMOVE NO. 1 ENGINE UNDER COVER |
| 6. REMOVE NO. 2 ENGINE UNDER COVER |
| 7. DRAIN MANUAL TRANSMISSION OIL |
Remove the drain plug and gasket to drain the oil.
Install a new gasket and the drain plug.
| 8. REMOVE NO. 2 FRAME CROSSMEMBER ASSEMBLY |
![]() |
Remove the 4 bolts, 4 nuts and frame crossmember.
| 9. REMOVE REAR PROPELLER SHAFT ASSEMBLY |
| 10. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 11. DISCONNECT WIRE HARNESS |
Disconnect the back-up light switch connector.
Disconnect speedometer sensor connector.
| 12. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the release cylinder.
| 13. REMOVE STARTER ASSEMBLY |
| 14. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Support the transmission rear side with a support stand.
Remove the 4 set bolts of the rear No. 1 engine mounting insulator.
Remove the 4 bolts, 4 nuts and frame crossmember.
| 15. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Remove the 4 bolts and mounting insulator.
| 16. REMOVE STIFFENER PLATE |
![]() |
Remove the 4 bolts and stiffener plate RH.
Remove the 4 bolts and stiffener plate LH.
| 17. REMOVE MANUAL TRANSMISSION ASSEMBLY |
![]() |
Using a transmission jack, support the transmission.
Remove the support stand from the rear side.
Remove the 5 bolts and transmission.