Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for DENSO Made)

STARTER (for DENSO Made) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A122908
  1. Install the starter and ground cable with the 2 nuts and bolt.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }

  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.

  1. Attach the terminal cap.



2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
  1. Coat a new O-ring with ATF, and install it to the oil filter tube.

  1. Install the oil filter tube with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Install the oil dipstick.



3. INSTALL FRONT FENDER SEAL
  1. Install the seal with the 5 clips.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).