Home › ENGINE ยท 2KD-FTV › STARTING › STARTER (for 2.7 kW Type)

STARTER (for 2.7 kW Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and front fender seal.



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


G039346E01
  1. Remove the transmission oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



5. REMOVE STARTER ASSEMBLY


    A122802
  1. Disconnect the starter connector.

  1. Open the terminal cap.

  1. Remove the nut and disconnect the starter wire.



    A122803
  1. Remove the 2 nuts, bolt, ground cable and starter.