Home › ENGINE ยท 1KD-FTV › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here


NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112147E01



3. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug, and drain the engine oil from the oil pan.

    NOTICE:
    Collect the oil in an oil disposal container.



4. REMOVE COMMON RAIL ASSEMBLY
(Click here)


5. REMOVE FUEL SUPPLY PUMP ASSEMBLY
(Click here)


6. REMOVE STARTER ASSEMBLY
  1. for DENSO Made: (Click here)
  2. for BOSCH Made: (Click here)


7. REMOVE OIL FILTER SUB-ASSEMBLY


B011502E02
  1. Using SST, remove the oil filter.

    SST
    09228-07501  

    HINT:
    Insert the drain hose in the oil filter. Put the disposal container beneath the drain hose to collect the oil from the oil filter.



8. REMOVE OIL COOLER COVER SUB-ASSEMBLY


A038741E01
  1. Disconnect the oil pressure switch connector and wire harness.

  1. Remove the 13 bolts, 2 nuts and oil cooler cover.



9. REMOVE OIL COOLER ASSEMBLY
  1. Loosen the 4 nuts.

  1. Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.

  1. Remove the 4 nuts, oil cooler and 2 gaskets.