ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION |
| 1. CHECK ACCELERATOR PEDAL ROD ASSEMBLY |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.
Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.
If the result is not as specified, refer to DTC P2120 (Click here).