DTC P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low |
DTC P0406 Exhaust Gas Recirculation Sensor "A" Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 5 seconds | EGR valve position sensor output voltage is below 0.1 V for more than 5 seconds (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 5 seconds | EGR valve position sensor output voltage is more than 4.9 V for higher than 5 seconds (1 trip detection logic). |
|

| 1.CHECK TERMINAL VOLTAGE (EGR VALVE POSITION SENSOR CONNECTOR) |
![]() |
Disconnect the EGR valve position sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E24-1 (VC) - E24-2 (E2) | Ignition switch ON | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to EGR Valve Position Sensor) |
Reconnect the electric vacuum regulating valve assembly connector.
|
| ||||
| OK | |
| 2.INSPECT EGR VALVE POSITION SENSOR |
Inspect the EGR valve position sensor (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (EGR VALVE POSITION SENSOR - ECM) |
Disconnect the EGR valve position sensor connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E24-1 (VC) - E7-18 (VC) | Always | Below 1 Ω |
| E24-3 (EGLS) - E6-33 (EGLS) | Always | Below 1 Ω |
| E24-2 (E2) - E7-28 (E2) | Always | Below 1 Ω |
| E24-1 (VC) or E7-18 (VC) - Body ground | Always | 10 kΩ or higher |
| E24-3 (EGLS) or E6-33 (EGLS) - Body ground | Always | 10 kΩ or higher |
Reconnect the electric vacuum regulating valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPLACE ELECTRIC EGR CONTROL VALVE ASSEMBLY |
Replace the electric EGR control valve assembly (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON for 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||