Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. DISCONNECT SKID CONTROL SENSOR WIRE


3. REMOVE TAILPIPE ASSEMBLY
  1. Remove the tailpipe for 1KD-FTV (Click here).

  1. Remove the tailpipe for 1GR-FE (Click here).

  1. Remove the tailpipe for 2TR-FE (Click here).

  1. Remove the tailpipe for 5L-E (Click here).

  1. Remove the tailpipe for 2KD-FTV (Click here).



4. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Disconnect the No. 3 parking brake cable .



5. DISCONNECT REAR BRAKE TUBE FLEXIBLE HOSE


F049944E06
  1. Using a union nut wrench, disconnect the brake line from the flexible hose.

  1. Using a screwdriver, remove the clip.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the flexible hose from the 3 way joint.



6. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY


C118719
  1. Support the axle housing.

    1. Jack up and support the vehicle's frame on stands.

    2. Lower the axle housing until the coil spring tension is free, and maintain this position.

  1. Remove the nut and 2 retainers.



    C118720
  1. Remove the 2 bolts.

  1. Disconnect the shock absorber and 2 bushes from the axle housing and frame.

  1. Remove the lock nut, bracket, 3 retainers and 2 cushions.



7. REMOVE REAR COIL SPRING
  1. Slowly lower the rear axle housing.

    NOTICE:
    Be careful not to snap the brake line or parking brake cable.

  1. While lowering the axle housing, remove the coil spring and insulator.