Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/ VSC)

BRAKE MASTER CYLINDER (w/ VSC) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


C201243
  1. for Manual Transmission:
    Disconnect the clutch reservoir hose from the master cylinder reservoir.

  1. Disconnect the brake fluid level warning switch connector.

  1. Using a union nut wrench, disconnect the 4 brake lines from the master cylinder and brake tube way.



    C201244
  1. Remove the 2 nuts and brake tube way.

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.