Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The security courtesy switch (engine hood courtesy switch) is built into the hood lock. This switch turns OFF when the engine hood is opened and turns ON when the engine hood is closed.

WIRING DIAGRAM


B281448E07


INSPECTION PROCEDURE

1.INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)
B282278E01
  1. Remove the security courtesy switch (engine hood courtesy switch) from the hood lock.

    1. for LHD: Click here
    2. for RHD: Click here

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Unlock position
    10 kΩ or higher
    Lock position
    Below 1 Ω

    Text in Illustration 
    *a
    Unlock position
    *b
    Lock position
    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH) (Click here)

C
REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH) (Click here)
A


2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)
  1. Disconnect the E2 hood lock assembly (security courtesy switch) connector.

  1. Disconnect the T36 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-1 - T36-9 (DSWH)
    Always
    Below 1 Ω
    E2-1 or T36-9 (DSWH) - Body ground
    Always
    10 kΩ or higher
    E2-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)