THEFT DETERRENT SYSTEM > Back Door Courtesy Switch Circuit |

| 1.INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH) |
Remove the back door lock assembly (Click here).

| *a | Latch Condition | *b | Open-latch |
| *c | Half-latch | *d | Full-latch |
| *e | Over-latch | - | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Open-latch (ON) | Below 1 Ω |
| Half-latch (ON) | Below 1 Ω | |
| Full-latch (OFF) | 10 kΩ or higher | |
| Over-latch (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - THEFT WARNING ECU AND BODY GROUND) |
Disconnect the B9 back door lock assembly connector.
Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B9-2 - T36-7 (CTY) | Always | Below 1 Ω |
| B9-1 or T36-7 (CTY) - Body ground | Always | 10 kΩ or higher |
| B9-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||