Home › DRIVE LINE › VF4B TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN TRANSFER OIL


2. REMOVE LOWER TRANSFER CASE PROTECTOR


    F043499
  1. Remove the 4 bolts and protector.



3. REMOVE REAR PROPELLER SHAFT ASSEMBLY
  1. Remove the rear propeller shaft (Click here).



4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Using SST, remove the lock nut and companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)



5. REMOVE EXTENSION HOUSING OIL SEAL


    F043484E01
  1. Using SST, tap out the oil seal.

    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil seal and extension housing contact surface.



6. INSTALL EXTENSION HOUSING OIL SEAL
  1. Coat the lip of a new oil seal with MP grease.



    F043486E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.

    SST
    09316-60011   (09316-00011)



7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Apply gear oil to the connecting area of the companion flange and output shaft.

  1. Install the companion flange to the output shaft.

  1. Using SST to hold the companion flange, install a new lock nut.

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)

    Torque:
    118 N*m{ 1,203 kgf*cm , 87 ft.*lbf }



8. INSTALL REAR PROPELLER SHAFT ASSEMBLY
  1. Install the rear propeller shaft (Click here).



9. INSTALL LOWER TRANSFER CASE PROTECTOR


    F043499
  1. Install the protector with the 4 bolts.

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }



10. ADD TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket and the case plug (for filler).

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }