Home › DRIVE LINE › VF4B TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN TRANSFER OIL


2. REMOVE LOWER TRANSFER CASE PROTECTOR


    F043499
  1. Remove the 4 bolts and protector.



3. REMOVE REAR PROPELLER SHAFT ASSEMBLY
(Click here)


4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Using SST, remove the lock nut and companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)



5. REMOVE EXTENSION HOUSING OIL SEAL


    F043484E01
  1. Using SST, tap out the oil seal.

    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil seal and extension housing contact surface.



6. INSTALL EXTENSION HOUSING OIL SEAL
  1. Coat the lip of a new oil seal with MP grease.



    F043486E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.

    SST
    09316-60011   (09316-00011)



7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Apply gear oil to the connecting area of the companion flange and output shaft.

  1. Install the companion flange to the output shaft.

  1. Using SST to hold the companion flange, install a new lock nut.

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)

    Torque:
    118 N*m{ 1,203 kgf*cm , 87 ft.*lbf }



8. INSTALL REAR PROPELLER SHAFT ASSEMBLY
(Click here)


9. INSTALL LOWER TRANSFER CASE PROTECTOR


    F043499
  1. Install the protector with the 4 bolts.

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }



10. ADD TRANSFER OIL