DTC C1232 Acceleration Sensor Stuck Malfunction |
DTC C1243 Acceleration Sensor Stuck Malfunction |
DTC C1245 Acceleration Sensor Output Malfunction |
DTC C1279 Acceleration Sensor Output Voltage Malfunction (Test Mode DTC) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1232 | At a vehicle speed of 10 km/h (6 mph) or more, either GL1 or GL2 (input signal) does not change for 30 seconds or more. |
|
| C1243 | While the vehicle speed changes from 30 km/h (19 mph) to 0 km/h (0 mph), the condition that the values of GL1 and GL2 do not change by 0.0294 G or more occurs 16 times or more. |
|
| C1245 | At a vehicle speed of 30 km/h (19 mph) or more, the difference between the forward and backward G calculated from the acceleration sensor value and that calculated from the vehicle speed exceeds 0.35 G for 60 seconds or more. |
|
| C1279 | Stored during Test Mode. |
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 30 km/h (19 mph) or more, turn the steering wheel and decelerate (depress the brake pedal) the vehicle.
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output (Click here).
Check if DTCs for zero point calibration of the yaw rate sensor (C1210) or for zero point calibration of the acceleration sensor (C1336) are output (Click here).
| Result | Proceed to |
| DTC relating to yaw rate and acceleration sensor is output | A |
| DTC relating to CAN communication system is output | B |
| DTC C1210 and/or C1336 is output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
|
| ||||
| OK | |
| 3.CHECK TERMINAL VOLTAGE AND RESISTANCE (IG, GND TERMINAL) |
Turn the ignition switch off.
Disconnect the yaw rate sensor assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Y1-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Y1-1 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Yaw Rate Sensor Assembly) |
|
| ||||
| OK | ||
| ||