DTC C1381 Acceleration Sensor Power Supply Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1381 | At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
| 1.CHECK TERMINAL VOLTAGE (IG TERMINAL) |
Turn the ignition switch off.
Disconnect the yaw rate sensor assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Y1-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Yaw Rate Sensor Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
Turn the ignition switch off.
Disconnect the yaw rate sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Y1-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 3 km/h (2 mph) or more for at least 10 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||