Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (w/ VSC)

CAN COMMUNICATION SYSTEM (w/ VSC) > PROBLEM SYMPTOMS TABLE


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Result List of Check CAN Bus Line 
Symptom
Suspected Area
See page
The result of "How to Proceed with Troubleshooting" is "Open in CAN Main Bus Line"
Open in CAN Main Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Check CAN Bus Lines for Short Circuit"
Check CAN Bus Lines for Short Circuit
Click here
The result of "How to Proceed with Troubleshooting" is "Check CAN Bus Line for Short to +B"
Check CAN Bus Line for Short to +B
Click here
The result of "How to Proceed with Troubleshooting" is "Check CAN Bus Line for Short to GND"
Check CAN Bus Line for Short to GND
Click here
The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

Communication Stop Mode Table 
Symptom
Suspected Area
See page
Skid Control (ABS/VSC/TRAC) not displayed on the intelligent tester
Skid Control ECU Communication Stop Mode
Click here
ECM (Engine) not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
Spiral cable (Steering Angle Sensor) not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
Yaw Rate Sensor not displayed on the intelligent tester
Yaw Rate Sensor Communication Stop Mode
Click here