Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (w/ VSC)

CAN COMMUNICATION SYSTEM (w/ VSC) > ECM Communication Stop Mode


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
When either condition below is met:
  1. ECM (Engine) is not displayed on "Bus Check".
  2. "ECM Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or ECM
  2. Harness or connector
  3. ECM

WIRING DIAGRAM


C190793E08


C234150E01


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


  1. for 1KD-FTV, 2KD-FTV:


    C190784E04

    1. Disconnect the E4, E5, E6 and E7 ECM connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E6-7 (E1) - Body ground
      Always
      Below 1 Ω
      E7-6 (E02) - Body ground
      Always
      Below 1 Ω
      E7-7 (E01) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      E4-1 (+B) - Body ground
      When battery's positive (+) voltage is applied to terminal E4-8 (MREL)
      11 to 14 V
      E5-2 (BATT) - Body ground
      Always
      11 to 14 V



  1. for 1GR-FE:


    C234154E01

    1. Disconnect the E14, E15 and E17 ECM connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E17-1 (E1) - Body ground
      Always
      Below 1 Ω
      E15-6 (E02) - Body ground
      Always
      Below 1 Ω
      E15-7 (E01) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      E14-1 (+B) - Body ground
      When battery's positive (+) voltage is applied to terminal E14-8 (MREL)
      11 to 14 V
      E14-2 (+B2) - Body ground
      When battery's positive (+) voltage is applied to terminal E14-8 (MREL)
      11 to 14 V
      E14-3 (BATT) - Body ground
      Always
      11 to 14 V

Result 
Result
Proceed to
OK (for 1KD-FTV)
A
OK (for 2KD-FTV)
B
OK (for 1GR-FE)
C
NG
D


B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE ECM (Click here)