DTC C1442 Invalid Data Received from Acceleration Sensor |
DTC C1443 Invalid Data Received from Yaw Rate Sensor |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1442 | With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. | Acceleration sensor (Yaw rate sensor assembly) |
| C1443 | With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. | Yaw rate sensor assembly |
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||