DTC P0489 Exhaust Gas Recirculation Control Circuit Low |
DTC P0490 Exhaust Gas Recirculation Control Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0489 | Open or short in E-VRV circuit for 5 seconds or more (1 trip detection logic) |
|
| P0490 | Open or short in E-VRV circuit for 5 seconds or more (1 trip detection logic) |
|

| 1.INSPECT E-VRV FOR EGR |
Inspect the E-VRV for EGR (Click here).
|
| ||||
| OK | |
| 2.INSPECT E-VRV FOR EGR (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the V1 E-VRV for EGR connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector and body ground.
| Tester Connection | Specified Condition |
| V1-1 - Body ground | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (E-VRV FOR EGR - ECM) |
![]() |
Disconnect the V1 E-VRV for EGR connector.
Disconnect the E6 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| V1-2 - EGR (E6-9) | Below 1 Ω |
| Tester Connection | Specified Condition |
| V1-2 or EGR (E6-9) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (E-VRV FOR EGR - INTEGRATION RELAY) |
![]() |
Remove the integration relay from the engine room junction block (Click here).
Disconnect the 1J integration relay connector.
Disconnect the V1 E-VRV for EGR connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| 1J-5 - V1-1 | Below 1 Ω |
| Tester Connection | Specified Condition |
| 1J-5 - V1-1 | Below 1 Ω |
| 1J-5 or V1-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||