Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

DTC    CB-13    USB Over Current Detection

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
CB-13
An "iPod" or USB device overcurrent malfunction
  1. "iPod" or USB device
  2. Harness or connector
  3. No. 1 stereo jack adapter assembly
  4. Radio receiver assembly

WIRING DIAGRAM


C240166E07


INSPECTION PROCEDURE

NOTICE:
The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the stereo jack adapter assembly.


NEXT


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are output frequently, replace the radio receiver assembly.

    OK:
    Malfunction disappears.



NG
Go to step 3
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

3.CHECK RADIO RECEIVER ASSEMBLY


    C225529E11
  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N3-1 (UPI) - N3-4 (UJSG)
    Always
    4.5 to 5.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 4
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)
  1. Disconnect the R28 radio receiver assembly connector.

  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R28-1 (USV1) - N3-1 (UPI)
    Always
    Below 1 Ω
    R28-4 (UGD1) - N3-4 (UJSG)
    Always
    Below 1 Ω
    R28-1 (USV1) - Body ground
    Always
    10 kΩ or higher
    R28-4 (UGD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)