AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > USB Audio System Recognition/Play Error |

| 1.CHECK USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Check if playable files are present on the USB device or "iPod".
Check if the USB device is a compatible format or "iPod" is a compatible version.
| Result | Proceed to |
| No playable files exist, or incompatible device format or version | A |
| Playable files exist, and compatible device format or version | B |
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R32 radio and display receiver assembly connector.
Disconnect the N5 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R32-1 (USV1) - N5-1 (USV1) | Always | Below 1 Ω |
| R32-2 (US1-) - N5-2 (US1-) | Always | Below 1 Ω |
| R32-3 (US1+) - N5-3 (US1+) | Always | Below 1 Ω |
| R32-4 (UGD1) - N5-4 (UGD1) | Always | Below 1 Ω |
| R32-5 (USG1) - N5-5 (UJSS) | Always | Below 1 Ω |
| R32-1 (USV1) - Body ground | Always | 10 kΩ or higher |
| R32-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| R32-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| R32-4 (UGD1) - Body ground | Always | 10 kΩ or higher |
| R32-5 (USG1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE) |
![]() |
Reconnect the R32 radio and display receiver assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N5-1 (USV1) - N5-4 (UGD1) | Ignition switch ACC | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | |
| 4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK |
Delete all files in the USB device or "iPod" and format/ restore it.
Save the data again and check if it can be played on the in-vehicle device.
|
| ||||
| OK | ||
| ||
| 5.REPLACE USB DEVICE OR "iPod" |
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| NEXT | |
| 6.CHECK USB DEVICE OR "iPod" |
Check if USB device or "iPod" is recognized by radio and display receiver assembly, or if information such as track, artist and album names are displayed on screen.
|
| ||||
| OK | ||
| ||