REAR DOOR BLACK OUT TAPE > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
![]() |
Using a moulding remover, detach the 2 clips and 2 claws.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
| 4. REMOVE DOOR PULL HANDLE |
![]() |
Remove the screw and door pull handle.
| 5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the screw.
Detach the 10 clips and remove the rear door trim board.
| 6. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH |
![]() |
Put protective tape around the rear door outer glass weatherstrip.
| *1 | Protective Tape |
Detach the 4 claws and remove the rear door outer glass weatherstrip.
| 7. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH |
![]() |
Detach the claw and 2 guides as indicated by the arrows in the order shown in the illustration.
![]() |
Disconnect the rear door inside locking cable and rear door lock remote control cable and remove the rear door inside handle.
| 8. REMOVE REAR DOOR NO. 2 TRIM BRACKET |
![]() |
Remove the 2 screws and rear door No. 2 trim bracket.
| 9. REMOVE REAR DOOR SERVICE HOLE COVER LH |
![]() |
Pull out the rear door inside locking cable, rear door lock remote control cable and wire harness from the rear door service hole cover, and then remove the rear door service hole cover.
| 10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH |
Temporarily install the rear power window regulator switch assembly with rear door armrest base panel.
Connect the cable to the negative (-) battery terminal.
Move the rear door glass so that the rear door glass channel can be seen.
Disconnect the cable from the negative (-) battery terminal.
Remove the rear power window regulator switch assembly with rear door armrest base panel.
![]() |
Partially remove the rear door glass run as shown in the illustration.
![]() |
Loosen the temporary bolt.
| *1 | Temporary Bolt |
Remove the screw and bolt.
![]() |
Remove the rear door window division bar together with the rear door glass run as shown in the illustration.
Remove the rear door window division bar from the rear door glass run.
| 11. REMOVE REAR DOOR GLASS RUN LH |
![]() |
Remove the front side of the rear door glass run.
| 12. REMOVE REAR DOOR QUARTER WINDOW GLASS LH |
![]() |
Remove the rear door quarter window glass.
| 13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Remove the rear door glass from the rear door window regulator assembly as shown in the illustration.
| 14. REMOVE NO. 2 BLACK OUT TAPE LH |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| No. 2 Black Out Tape | 40 to 60°C (104 to 140°F) |
![]() |
Pull back an edge of the No. 2 black out tape and pull it parallel to the vehicle body to remove it.