2014 Hilux · Service Manual BODY ELECTRICAL

Display does not Dim when Light Control Switch is Turned ON

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for T-Connect.


1. CHECK IMAGE QUALITY SETTING
  1. Display the "Display Settings" screen.

  1. Turn the headlight dimmer switch assembly to the tail or head position.

  1. Check if "Day Mode" on the display adjustment screen is on.

    OK:
    "Day Mode" setting is off



NG
TURN "Day Mode" SETTING OFF
OK


2. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E278187
    Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]

  1. Check that the display for "TAIL" changes between ON and OFF according to the headlight dimmer switch assembly operation.

    OK:
    Headlight Dimmer Switch Assembly Condition
    Display
    Tail or head
    ON
    Off
    OFF

HINT:
The display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

  1. Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the headlight dimmer switch assembly operation.

    OK:
    Headlight Dimmer Switch Assembly Condition
    Display
    Tail or head
    DIM
    Off
    BRIGHT

HINT:
The display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← Display does not Dim when Light Control Switch is Turned ON (Aug 2012 – Jul 2013)Panel Switches do not Function (Jun 2011 – Jul 2012) →