REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE V-BANK COVER |
Remove the 2 nuts and the V-bank cover.

| 3. REMOVE NO. 2 VENTILATION HOSE |
![]() ![]() |
| 4. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the vacuum hose.

Disconnect the MAF meter connector.
Remove the 2 wire harness clamps.
Loosen the 2 hose clamps.

Remove the 2 bolts and air cleaner.
| 5. REMOVE THROTTLE BODY |
Disconnect the throttle motor connector.

Remove the 4 bolts and throttle body.
Remove the gasket from the intake air surge tank.
| 6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1) |
![]() ![]() |
Disconnect the oil control valve connector.
Remove the bolt and oil control valve.
Remove the O-ring from the oil control valve.
| 7. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2) |
![]() ![]() |
Disconnect the oil control valve connector.
Remove the bolt and oil control valve.
Remove the O-ring from the oil control valve.



