2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

  1. A111696E02
    Measure the resistance between the terminals.

    Standard resistance:
    6.9 to 7.9 Ω at 20°C (68°F)

    If the result is not as specified, replace the oil control valve assembly.

  1. A099422E01
    Connect the battery's positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

    Specified condition:
    Condition
    Specified Condition
    Battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in the illustration
    Battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in the illustration

    If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.

← REMOVAL (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →