2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE V-BANK COVER

  1. A112983
    Remove the 2 nuts and the V-bank cover.


3. DISCONNECT NO. 2 VENTILATION HOSE

A075594

4. REMOVE AIR CLEANER ASSEMBLY

  1. A075595
    Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.

  1. A075596
    Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.


5. REMOVE THROTTLE BODY

  1. A075599
    Disconnect the throttle motor connector.

  1. Remove the 4 bolts and throttle body.

  1. Remove the gasket from the intake air surge tank.


6. REMOVE INTAKE AIR SURGE TANK

A076500E02
  1. Disconnect the 2 water by-pass hoses.

  1. A075644E01
    Disconnect the purge line hose.

  1. A075645E01
    Disconnect the ventilation hose.

  1. A075646E01
    Disconnect the 2 VSV connectors.

  1. Disconnect the throttle body with motor connector.

  1. Separate the 3 wire harness clamps and hose clamp.

  1. A076501E01
    Remove the 2 bolts and throttle body bracket.

  1. A076502E01
    Remove the bolt and oil baffle plate.

  1. Remove the 4 bolts and 2 surge tank stays.

  1. A075648E01
    Remove the 2 nuts.

  1. Using an 8 mm hexagon socket wrench, remove the 4 bolts, intake air surge tank and gasket.


7. REMOVE INTAKE MANIFOLD

A076533E01
  1. Disconnect the 6 fuel injector connectors.

  1. Remove the 10 bolts, intake manifold and 2 gaskets.


8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

A111701
  1. Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →