2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A121919
    Remove the nut, and then disconnect the lead wire from terminal C.

  1. A121920
    Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch assembly to the starter drive housing.

  1. Remove the magnet starter switch assembly.

  1. Remove the return spring.

  1. A121921E01
    Remove the plunger from the pinion drive lever.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A121922
    Remove the 2 bolts and starter yoke assembly from the starter drive housing.

  1. Remove the cover ring from the planet carrier.

  1. A121923
    Remove the plate from the planet carrier.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

NOTICE:
Do not drop the starter armature assembly.

  1. Hold the starter yoke between aluminum plates in a vise.

    NOTICE:
    Do not damage the starter yoke assembly.

  1. A121924
    Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

  1. Remove the seal ring.

  1. A121925E01
    Remove the slotted washer.

  1. A121926E01
    Remove the washer.

  1. Remove the starter commutator end frame from the starter yoke assembly.

  1. A121927E02
    Remove the starter brush holder from the starter armature assembly.

    NOTICE:
    Do not pull on the rubber part.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A105361E01
    Remove the starter armature from the starter yoke.


5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A122390
    Remove the 3 planetary gears from the planet carrier.

  1. A121928E02
    Remove the starter clutch sub-assembly, pinion drive lever and cover from the starter drive housing.

  1. A121929E01
    Using a screwdriver, move the pinion stop collar to the starter clutch.

  1. A121930E01
    Using a screwdriver, remove the snap ring.

  1. A105365
    Remove the pinion stop collar and starter clutch sub-assembly from the planet carrier shaft.


6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY

  1. A105364
    Using 2 screwdrivers and a hammer, tap off the snap ring.

  1. Remove the washer from the planet carrier shaft.

  1. A117267E01
    Remove the planet carrier shaft from the planet carrier.

  1. Remove the intermediate sealing and the 3 damper rubbers from the planet carrier.

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →