INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
- NOTICE:
- Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
Install the spiral cable.
- NOTICE:
- When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
Connect the connectors to the spiral cable.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
| 2. INSTALL UPPER STEERING COLUMN COVER |
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() ![]() |
Install the cover lower with the 3 screws.
| 4. ADJUST SPIRAL CABLE |
![]() ![]() |
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
- NOTICE:
- Do not use the airbag wire harness to turn the spiral cable.
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

- NOTICE:
- Do not use the airbag wire harness to turn the spiral cable.
- HINT:
- The spiral cable will rotate approximately 2.5 turns to the left and right from the center.
| 5. INSTALL STEERING WHEEL ASSEMBLY |
for 3 spoke:

Apply the silicon grease to the steering wheel.
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
- Torque:
- 50 N*m{ 510 kgf*cm , 37 ft.*lbf }
| 6. INSTALL STEERING PAD |
Support the steering pad with one hand.

Connect the connector to the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
- Torque:
- 8.8 N*m{ 90 kgf*cm , 78 in.*lbf }
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).


