The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.
DTC Code
DTC Detection Condition
Trouble Area
P0560
Open in the TCM back-up power source circuit (1-trip detection logic).
Open in back-up power source circuit
TCM
HINT:
If DTC P0560 is stored, the TCM does not store other DTCs.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK DTC OUTPUT (ECD SYSTEM DTC P0560)
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / DTC.