P0500 Vehicle Speed Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2013
Versions by build date: Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The vehicle speed sensor (SPD1) outputs a 4-pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the TCM. The TCM determines the vehicle speed based on the frequency of these pulse signals.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0500 |
All conditions below are detected 500 times or more continuously (2-trip detection logic): (a) No signal from vehicle speed sensor (SPD1) is input to TCM while 48 pulses of speed sensor (SP2) signal are sent (b) Vehicle speed is 9 km/h (6 mph) or more for at least 4 seconds (c) PNP switch is off (shift lever not in P or N) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
Drive the vehicle.
Read the value displayed on the tester.
ECT Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Vehicle Speed
Vehicle speed/
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
Speed indicated on speedometer
- OK:
- Vehicle speed displayed on tester and speedometer display are equal.
|
|
||||
| OK | ||
| ||
| 2. CHECK COMBINATION METER ASSEMBLY (SPD1 SIGNAL WAVEFORM) |
Remove the combination meter assembly with the connector(s) still connected.

Move the shift lever to N.
Jack up the vehicle.
Turn the ignition switch to ON.
Check the signal waveform according to the condition(s) in the table below.
- Measurement Condition:
Terminal No. (Symbol)
Tool Setting
Condition
C25-6 - Body ground
5 V/DIV., 20 msec./DIV.
Vehicle speed 20 km/h (12 mph)
- OK:
- The waveform is displayed as shown in the illustration.
Text in Illustration *a
Component with harness connected
(Combination Meter Assembly)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TCM) |
Disconnect the C25 combination meter assembly connector.
Disconnect the T38 TCM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
C25-6 - T38-25 (SPD1)
Always
Below 1 Ω
C25-6 or T38-25 (SPD1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
