P0617 Starter Relay Circuit High
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
DESCRIPTION
While the engine is being cranked, battery voltage is applied to terminal STA of the TCM.If the TCM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The TCM then illuminates the MIL and stores the DTC.
This monitor runs when the vehicle is driven at more than 20 km/h (12.4 mph) for over 20 seconds.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0617 |
All conditions are met (1-trip detection logic): (a) Vehicle speed is more than 20 km/h (12.4 mph). (b) Engine speed is more than 1000 rpm. (c) STA signal is ON. (d) Battery voltage (10.5 V or higher) is applied to the TCM for 20 seconds. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- The following troubleshooting flowchart is based on the premise that the engine can be cranked normally. If the engine does not crank, proceed to the problem symptoms table.
| 1. READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
Read the value displayed on the intelligent tester.
Crank the engine.
Read the value displayed on the intelligent tester.
ECT Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Starter Signal
Starter signal/
ON or OFF
- ON: Engine cranking
- OFF: Engine not cranking
-
- OK:
- Starter Signal is only ON when the engine is being started (during cranking).
- ON: Engine cranking
|
|
||||
| OK | ||
| ||
| 2. CHECK TCM (STA VOLTAGE) |
Disconnect the T19 TCM connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
T19-11 (STA) - T19-1 (E1)
Ignition switch ON and shift lever in P or N
Below 2 V
|
|
||||
| OK | |
| 3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the N1 park/neutral position switch connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
4 (B) - 5 (L)
Shift lever in P
Below 1 Ω
4 (B) - 5 (L)
Shift lever in N
Below 1 Ω
4 (B) - 5 (L)
Shift lever not in P
10 kΩ or higher
4 (B) - 5 (L)
Shift lever not in N
10 kΩ or higher
2 (RB) - 5 (L)
Shift lever in P, R, N, D, 3, 2 or L
10 kΩ or higher
|
|
||||
| OK | ||
| ||
