2014 Hilux · Service Manual ENGINE

Starter Signal Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

While the engine is being cranked, current flows from terminal ST2 of the ignition switch to the ST fuse and also flows to terminal STA of the ECM (STA signal).

WIRING DIAGRAM

Refer to DTC P0617 (Click here).

INSPECTION PROCEDURE

HINT:
This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to the problem symptoms table (Click here).

NOTICE:
If the ECM is replaced, the new ECM needs initialization (Click here).


1. READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine / Data List / Starter Signal.

  1. Read the values.

    Standard:
    Ignition Switch Position
    Starter SIG
    ON
    OFF
    START
    ON



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK WIRE HARNESS (ECM - STARTER RELAY (Marking: ST))

  1. A310677E01
    Disconnect the E5 ECM connector.

  1. A/T: Remove the starter relay from the engine room relay block.

  1. M/T:Disconnect the 2O junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    A/T 
    Tester Connection
    Specified Condition
    Relay block starter relay terminal 1 - E5-7 (STA)
    Below 1 Ω
    Relay block starter relay terminal 1 or E5-7 (STA) - Body ground
    10 kΩ or higher

    Standard resistance:
    M/T 
    Tester Connection
    Specified Condition
    2O-19 - E5-7 (STA)
    Below 1 Ω
    2O-19 - E5-7 (STA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM (Click here)


← Starter Signal Circuit (Aug 2012 – Jul 2013)Starter Signal Circuit (from Aug 2014) →